Enter Quantity
Item #
510082
GAS PACK 3.5/110K 1-230 13S |
 |
One phase, 230 volts Hot surface to pilot ignition Multi-port in-shot burners Tubular aluminized steel heat exchanger FEATURES: Utility Connections Made Easy - Gas and electric utility knockouts are provided through the bottom as well as the side of the unit. Utility connections can be made quickly and with a minimum amount of field labor. A field supplied and field installed electrical disconnect switch must be installed. Convertible Airflow Design - The bottom duct openings are covered when they leave the factory ready to be used for a side supply/side return application. If a bottom supply/bottom return application is desired, you simply remove the two panels from the bottom of the unit and place them in the side supply/side return duct openings. No panel cutting is required and no accessory panel is necessary. Convertible airflow design allows maximum field flexibility and minimum inventory. Durable Finish - With a heavy duty cabinet made of powder-painted, galvanized steel the neutral color blends into surrounding areas. The powered paint, provides a better paint-to-steel bond, which resists corrosion and rust creep. The special primer formulas and glossy earth-tone finish ensure less fading when exposed to sunlight and offers a more attractive on-site appearance. This paint finish exceeds ASTM-B1 17 standards for 750 hours salt spray rating. The highest in the industry. Full Perimeter Base Rails - The easily removable base rails provide a solid foundation for the entire unit and protects the unit during shipment. The rails provide forklift access from all sides, and rigging holes are also provided so that an overhead crane can be used to place the unit on a roof. On applications where the unit is placed on a pad, the base will keep the unit off the pad to deter corrosion. On applications where height is limited, the 2-3/8 inch high base rails may be removed on location. Top Discharge - The top discharge condenser fan does not disrupt neighboring areas nor does this dry out vegetation surrounding the unit. The warm air from the top-mounted fan is blown up away from the structure and any landscaping. This allows compact location on multi-unit applications. Condenser Coil Grille - A multi-piece totally enclosed, rigidly mounted condenser coil grille provides protection from objects and personnel after installation and provides protection during transit and installation. Low Operating Sound Level - The upward air flow carries the normal operating noise up and away from the living area. The rigid top panel effectively isolates any motor sound. Isolator mounted compressor and the rippled fins of the condenser coil muffle the normal fan motor and compressor operating sounds. The unique formed base pan also aids in sound alterations with its "Super-Structure" design. This design strategically places embossments in the pan for optimum strength and rigidity. Fan System - All models operate over a wide range of design conditions with a 3 speed direct drive fan motor. These units easily match all types of applications and provides greater on-site flexibility to match all types of applications and provides greater on site flexibility to match comfort requirement. Single phase models have the "Comfort-Match" system that allows different speed taps for heating or cooling operations. This allows maximum comfort conditions. Simple Control Circuit - A low voltage printed circuit board contains a diagnostic indicator light and a low voltage terminal strip. An additional set of pin connectors is also provided to simplify the field interface of external controls. Mate-n-lock plug connectors are used. The electrical control box is not located in the compressor compartment. The controls are mounted on a "Control-Tilt" control panel to allow the access cover to be removed for troubleshoo
110,000,3.5 Tons,47.25,49.13,41.50,475
|
$ 2068.75 per EA
1 per package
475 lbs
|